Why Choose the Partex ECHS295GREEN 2:1 Green Heat Shrink Tubing?
The Partex ECHS295GREEN is a professional green 2:1 heat shrink tubing designed for electrical wire insulation, cable identification, conductor protection and general wiring applications. Featuring a nominal supplied diameter of 9.5 mm and a nominal fully recovered diameter of 4.7 mm, this heat shrink sleeving provides a neat, close-fitting protective covering around suitably sized electrical wires, cable assemblies and components.
The 2:1 shrink ratio allows the tubing to recover to approximately half its original internal diameter when heated correctly. This enables the sleeving to conform around compatible conductors, cable joints and wiring assemblies, providing an additional insulating layer while helping protect covered surfaces against abrasion and general handling wear.
Supplied in a practical 75 m pack, the ECHS295GREEN is suitable for electrical contractors, control panel builders, equipment manufacturers and maintenance engineers requiring consistent heat shrink sleeving for repeated installation tasks. Its distinctive green finish supports visual cable identification and organised wiring systems in electrical, electronic and industrial applications.
Key Advantages
- 2:1 heat shrink ratio allows the tubing to recover to approximately half its original supplied diameter.
- 9.5 mm nominal supplied diameter accommodates compatible electrical cables, wire bundles and components.
- 4.7 mm nominal fully recovered diameter provides a close-fitting sleeve after correct heat application.
- Green colour supports visual cable identification and organised wiring installations.
- Provides an additional layer of electrical insulation around suitably sized conductors and connections.
- Helps protect covered wiring against abrasion and general mechanical handling.
- Flexible tubing can be cut to the required length for individual installation tasks.
- Heat-activated recovery creates a tidy finish without conventional tape wrapping.
- 75 m pack quantity supports electrical assembly, manufacturing and maintenance work.
- Suitable for electrical, electronic, industrial and general cable management applications.
Key Features
- Partex ECHS295GREEN heat shrink tubing.
- 2:1 shrink ratio for controlled diameter reduction.
- Nominal supplied diameter of 9.5 mm.
- Nominal fully recovered diameter of 4.7 mm.
- Distinctive green finish for cable identification applications.
- Heat-activated shrinking for a close-fitting protective covering.
- Suitable for compatible electrical conductors, cables and wiring assemblies.
- Provides an additional layer of electrical insulation.
- Helps protect covered wires and compatible cable joints against abrasion.
- Can be cut into individual sleeves to suit installation requirements.
- Suitable for installation using controlled hot-air heating equipment.
- Total supplied length: 75 m.
Reliable 2:1 Heat Shrink Protection and Green Cable Identification
The Partex ECHS295GREEN is designed to create a close-fitting protective sleeve around compatible electrical cables and components. The tubing is positioned over the required section before controlled heat is applied evenly using suitable hot-air equipment. As it warms, the material contracts around the underlying cable or component, helping produce a tidy insulating covering and a professional finish.
With a nominal diameter of 9.5 mm before shrinking and 4.7 mm after full recovery, this tubing is suitable for applications requiring a larger sleeve than smaller-diameter heat shrink products. It should be selected so that it passes over the component before heating and contracts sufficiently to grip it afterwards. Its green finish can support an established cable identification scheme, while the 75 m supply length allows installers to cut sleeves to the required dimensions. Green sleeving alone should not be assumed to provide compliant protective earth identification where green/yellow marking is required.
Typical Applications
- Electrical wire insulation and protection.
- Control panel wiring and cable organisation.
- Industrial cable identification and colour coding.
- Covering compatible cable joints and conductor connections.
- Electrical equipment assembly and manufacturing.
- Industrial automation and instrumentation wiring.
- Protection of compatible cable terminations and wire bundles.
- Machinery wiring and electrical harness production.
- General cable management and protective sleeving.
- Electrical maintenance, workshop repairs and equipment refurbishment.
